Part Number: 202-6005Application: NISSAN 2.0L (SR20DE/DET) 4-CYLPress Fit – Rod Bolt Installation[1] Please check the part-number(s) for your applicationagainst the part-number(s) listed on the instruction sheet.[2] Make sure there is an adequate chamfer around the topof the connecting rod bolt hole to clear the radius underthe head of the bolt.[3] Press the bolts into the connecting rods and install therod caps.[4] Use ARP Ultra-Torque Fastener Assembly Lubricantto lubricate the threads of the bolt and the nut face. Theninstall the nuts onto the bolts and tighten them hand tight.[5] ARP recommends using the STRETCH METHOD whentightening the bolts. Following the instructions for using astretch gauge, Stretch the bolts to . 0065 – . 0070 .[6] If you do not have a stretch gauge, torque the bolts to45 ft-lbs using ARP Ultra-Torque FastenerAssembly Lubricant.[7] The connecting rods should always be re-sized after newrod bolts are installed.[8] A log should be kept on the original non-torqued length ofeach bolt. Bolts that have any permanent deformation orhave increased in non-torqued length by more than .001in. should be replaced.